10x18 Norton CTU Cylindrical

                            10 x 18 NORTON TYPE "CTU" SEMI AUTOMATIC CYLINDRICAL GRINDER
                                                        WITH ABOVE THE WHEEL DRESSER

                                                                    S/N 24543    New: 1962

STANDARD CATALOG SPECIFICATIONS
Nominal length..................................... 18"
Maximum swing...................................... 10 31/32"
Nominal swing...................................... 10"
Maximum diameter work ground w/30" wheel........... 10"

GRINDING WHEELS
Wide capacity...................................... 30" x 4" x 12"

WHEEL AND WORK CENTER DISTANCES
Maximum............................................ 21"
Minimum............................................ 8 1/4"
Coolant tank capacity (U.S. Gallons)............... 75
Coolant pump capacity (Gallons per minute)......... 21
Hydraulic oil reservoir capacity (U.S. Gallons).... 38
Lubricating oil reservoir capacity (U.S. Gallons).. 3 1/2"

SWIVEL TABLE ADJUSTMENT (Inches per ft. on dia.)
Machine length..................................... 18"
Maximum taper...................................... 3 1/2"

Note:  Actual tapers ground depend on wheel diameter, work
       diameter and length.  Also on the location of the taper
       with reference to the pivot point.

HEAD STOCK
Spindle diameter................................... 4 1/8"
Center diameter.................................... 1 3/4"
Center taper....................................... No. 14 Jarno
Work speeds, AC Motor............... 50 80 125 200 RPM
Work speeds, DC Motor.............................. 30 275 RPM

FOOT STOCK
Spindle diameter................................... 2 3/4"
Center diameter.................................... 1 3/4"
Center taper....................................... No. 14 Jarno

BASE WAYS
Width of flat way.................................. 2 1/2"
Width of V way (Projected)......................... 2 1/2"
Lubrication......................... Automatic pressure

WHEEL SLIDE
Length of bearing ways............................. 37 3/8"
Width of flat way.................................. 5 5/8"
Width of V way (Projected)......................... 4 11/32"
Overall width of ways (Projected).................. 20 5/8"
Total bearing area (Projected)..................... 372 sq. in.
Lubrication......................... Automatic pressure
Automatic rapid advance stroke (Max)............... 4"

WHEEL SPINDLE
Material............................ Heat treated alloy steel
Large bearing (L.H.)................ 3 1/2" x 8 5/16"
Small bearing (R.H.)................ 3 1/2" x 7 1/8"
Number of speeds.................... 3
Diameter of pulleys................. 14 1/8"  11 5/16"  9 9/16"
Drive from motor.................... 7 Vee belts
Lubrication......................... Automatic flood
Reciprocation....................... 0   3/8"

TABLE SPEEDS
Range of speeds (Inches per minute)........... 2"   240"
Number of speeds.............................. Infinite

MOTORS
Wheel drive................................... 15 HP, 1800 RPM
Work drive.................................... 1 HP, 1200 RPM
Hydraulic & lubricating....................... 1 HP, 1200 RPM
Coolant pump.................................. 1/4 HP, 1800 RPM

EQUIPMENT & FEATURES
Automatic Grinding Cycle Including
Automatic wheel head retraction.
Wheel guard mounted hydraulic truing.
Hydraulic operated tail stock.
Plunge.
Coolant in base.
30” OD Wheel.

Specifications are deemed accurate, however, subject to verification or prior sale.